Whirlpool AGB 664/WP Manual For Use And Installation page 24

12 TANK DRAIN
After completing the wash cycle proceed as follows:
-set the master switch to "OFF";
-disconnect the wall master switch;
-turn water supply pipe off;
-remove overflow H (to allow the appliance tostart draining)(Fig.10)(only in the models
without discharge pump);
-remove filter G on draining completion (Fig.10);
-wash the tank interior and filters with suitable products;
-place filter and the overflow back to the relevant positions.
13 PERIODICALLY
Make sure water hardness is not over 15° Fr (150 ppm).
Make sure water temperature and pressure ratesare correct; a pressure rate of over 400 Kpa
might damage appliance components. Remove any deposits from nozzles and blades.
Remove the 1 washing and rins 7 arms by undoing the lock nut 3 (Fig.7 ).
Clean the wash rotors and rinse under a jet of clean water.
Clean all the jets both washing and rinsing using a jet of clean water.
When cleaning the jets do not use tools which could damage the jet(s) orifice.
Replace all parts with care checking that all are positioned in their original position.
Clean the exterior of the machine with a damp cloth.
Clear all solid leftovers (bones, peel, etc.) from the plates. Plates soiled with cheese should
be left to soak in cold water first.
13.2 GLASS WASHING
Place glasses upside down inside the relevant container, (Fig. 5-8).
13.3 CUTLERY WASHING
Cutlery must be placed loose inside the special holders.
We recommend using the relevant partitions to wash cutlery vertically. For washing, place
cutlery upright as shown, (Fig. 9).
13.4 WASHING LIQUID
Daily add non-foaming washing liquid after tank water has reached the required washing
temperature.The washing liquid should be used in the recommended quantity and added every
4 or 5wash cycles. The most suitable proportion for best performance may be found during use.
13.5 POLISHING LIQUID
Periodically check the level of rinse surfactant. Dilute with water if it is too dense.
See instructions at chapter 6, for possible proportion variations of the polishing liquid.
14 FAULT CONDITION
Do not move or start the machine, but turn off the mains isolator, close the water entry tap
and advise the technical service department or other specialized personnel.
INSTRUCTIONS FOR USER
24 ENGLISH