Table of Contents
Advertisement
Safety
If your water system is full and cold, and the water
heater is ignited, the system can see pressures as
high as 120 psi before the relief valve starts to open
Since the water system normally operates in the 40-psi
range, the expanding water does put unusual stress
on the system This normally does not cause any
problems, but the stress is easily alleviated As the
water is heating, simply open any faucet and run as
little as a cup of water Removing this small amount of
water will reduce the pressure buildup significantly.
For fun, watch the sequence of events your family goes
through when you park the trailer and ignite the water
heater More than likely, someone will run water and
relieve the pressure without even realizing it
Fantastic Vent Fan
The high-volume roof vent system is designed to
quickly exhaust stale, hot air and draw in fresh air It
is great to use when the outside temperature does not
call for air conditioning, but heat has built up in your
trailer
Operation
1
Open dome approximately 3 in or more (ceiling fan
has a built-in safety switch that will not allow motor
to operate unless dome is partially open)
2
Turn 3-speed knob to desired performance level
(3-Low, 2-Medium, 1-High, O-Off)
3
Open window(s) or door for airflow.
The source of airflow is determined by the number of
window(s) or door opened For best results, close all
roof vents and open one window that is the greatest
distance from the ceiling fan
NOTE
Never place Lindeen™ or a like cover over ceiling
fan. Greatly restricted airflow and increased sound
levels will occur.
Classic
When Thermostat Equipped
1
Follow the previous operation steps one through
three
2
Select the desired temperature or comfort level on
the thermostat The fan motor will now start and
stop automatically as the interior temperature of
the trailer exceeds or drops below the selected
level
NOTE
Fan motor will not start if temperature selected is
warmer than interior temperature of the trailer.
Cleaning Instructions
1
Turn fan motor off
2
Remove eight painted flat head Phillips screws
around perimeter of screen insert only
3
Clean screen with soap and water solution, dab
dry with a soft cloth, and reinstall
SeeLevel II Monitor Panel
SeeLevel II Tank Monitor
Manufacturer: Garnet Technologies Ltd
201 M&M Ranch Rd
Granbury, TX 76049
877-668-7813
www sales@rvgauge com
The display is the only system component that is
accessed by the user All user input to the display is
done using the four buttons along the bottom of the
display
Interior
5-21
Advertisement
Chapters
Table of Contents
