Table of Contents
Advertisement
Connecting the charging cradle (if included)
If you need to disconnect the plug from the charging cradle,
press the release button
Setting up the handset for use
Inserting the battery pack and closing the battery cover
◆
◆
¤
Insert the plug into the socket
as shown in the enlarged view.
¤
Insert the battery pack.
¤
Place the leads in the lead
guides.
2
1
and disconnect the plug 2.
1
The display is protected by a plastic film.
Please remove the protective film!
Warning
Place the battery leads in the lead guides so that the battery cover cannot catch on
leads and damage them when it is closed.
¢
Use only the rechargeable battery pack recommended by Gigaset Communications
GmbH (
p. 12), i.e. never use a conventional (non-rechargeable) battery pack as this
could result in significant health risks and personal injury. For example, the battery
pack could explode. The phone could also malfunction or be damaged as a result of
using batteries that are not of the recommended type.
4
¤
Connect the flat plug from the power supply 1.
¤
Plug the mains adapter into the plug socket 2.
¤
Place the cover on the battery compartment
as shown in the diagram, then push it up
until it clicks into position.
If you need to open the battery cover, for
instance to replace the batteries:
¤
Press down on the battery cover below its
upper end and slide the cover down.
2
1
Advertisement
Table of Contents
