Panasonic Quasar PV-D300 Service Manual page 5

Playing Back Recordings
Playback on EVF or LCD Monitor
D
1
(PV-L650 shown)
Speaker
3 E
STILL
B
PLAY
REW FF
A
STOP
C
POWER
REC
2
VCR CAMERA
OFF
Playing Back Recordings (continued)
TV Playback or Viewing
Connect Camcorder to a TV to view
playback or recordings in progress.
TV with AUDIO/VIDEO IN Jacks.
TV
To Audio In
To Video In
Audio/Video
Cable
(Supplied)
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
To Audio/
Video Out
RF Adaptor
optional
VHF Antenna
300 ohm-75 ohm
CH 3/4 Selector
transformer
or F Connector
UHF Antenna
TV/VCR
Selector
Back of TV
VHF Connecting
Cable
To VHF Antenna
VHF
Terminal
UHF
Before you begin...
• Connect Camcorder to power source.
• Insert recorded tape.
1
Press LCD-OPEN and swing LCD
monitor fully open.
• If you want to playback on EVF,
close and lock LCD monitor.
2
Set POWER to VCR.
Power lamp lights.
• If tape has no record tab, auto
playback begins.
• EVF or LCD monitor turns on/off by
the POWER switch.
• EVF shuts off when LCD monitor is
opened and turns back on when
LCD is closed.
3
Playback function buttons.
A REW(ind) : rewind tape.
B PLAY : play tape.
C STOP : stop tape.
D BRIGHT : adjust LCD monitor
brightness.
E VOLUME : Adjust volume of
speaker.
Press "T" : Volume up(+).
Press "W" : Volume down(-).
I I I I - - - - + I I I I - - - -
VOLUME VOLUME
Note:
• Using LCD monitor reduces battery
operating time.
• Return LCD monitor to locked position
when not in use.
Before you begin...
• Connect Camcorder to power source.
• Make all TV-Camcorder connections.
1
Set POWER to:
VCR view playback.
CAMERA view picture as it is
recorded.
2
Turn TV ON and set to LINE
INPUT.
See TV owner's manual.
3
Begin playback or recording.
If TV has no VIDEO/AUDIO IN jacks,
connect PV-RF16 RF Adaptor
(optional). Tune TV to CH 3 or 4 to
match RF Adaptor CH 3/4 Selector.
Set Adaptor's TV/VCR Selector to
VCR for playback.
To watch TV only,
a
Set Camcorder POWER to OFF.
b
Set RF Adaptor TV/VCR Selector to TV.
c
Turn TV ON and select channel.
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical Code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
PV-D300 / VM-D100 / PV-L550 / PV-L600 / PV-L650 / VM-L450
Special Effects
STILL
PLAY
UP
FF
REW
DOWN
MENU
DISPLAY
STOP
Note:
• During search, horizontal noise bars will appear. Audio is muted.
• To protect video heads and tape, operating modes will revert as follows after 5 minutes:
Still Stand-by
Stand-by Power off (when Battery Pack is used).
• Tape auto-rewinds if played or fast forwarded to end.
Tracking Control
Playing Back Recordings in a VCR
Load Battery in PlayPak
Insert Cassette in PlayPak
1
2
3
Load Detector
Remove Cassette
1
2
7
Before you begin...
• Connect Palmcorder to power source.
• Insert recorded tape.
• Set POWER to VCR.
Quick Visual Search
Search Speed
SP (Standard Play) : 3 times normal.
SLP (Super Long Play) : 9 times normal.
During playback, press:
FF : fast forward search
REW : rewind search
Press again or press PLAY for normal play.
Still Picture
Press STILL to freeze picture.
Press again for normal play.
This feature is works best in SLP mode.
Auto Tracking
Continuously analyzes each recording for
optimum picture quality.
Manual Tracking
Some recordings require manual
adjustment to reduce noise.
Press UP or DOWN until Playback
picture clears up.
Press DISPLAY to return to Auto Tracking.
Remove Battery lid and insert AA
battery.
• Do not reverse polarity.
• Replace battery when tape loading/
unloading takes longer than usual.
1
Turn cassette Tape Wheel
in direction of arrow to take up any
slack.
2
Slide RELEASE to open cassette lid.
3
Insert the cassette with the
window up and on the left, then snap
lid shut.
• Do not obstruct cassette reel while
loading.
• Allow PlayPak Load Detector to fully
retract before using in VHS VCR.
1
Slide RELEASE and wait for lid to
open.
2
Push cassette out through hole in
bottom of PlayPak with your finger.