SMC Networks ELITECONNECT SMC2502W User Manual page 164

Access Manager that does not use NAT.
clear dhcpserver
Reset the currently configured DHCP server value.
show dhcpserver
Show the currently configured DHCP server value.
set forwardipbroadcasts none | port-list
Specify the ports that should have the
show forwardipbroadcasts
Show the list of ports that have IP broadcast forwarding enabled.
set controlserver ip-address
Set the Access Manager's Control Server IP address.
clear controlserver
Clear the Access Manager's Control Server IP address.
show controlserver
Show the Access Manager's Control Server IP address.
set ipsecsecret [secret secret]
Set the IPSec shared secret. Prompts for the secret if not entered on the
command line.
show ipsec
This command shows PPTP and L2TP settings.
set ipsec on | off
Enable or disable IPSec.
clear ipsecsecret
If IPSec is enabled, this command disables it when clearing the secret.
set espencryption [des] [3des] [blowfish] [cast] [none]
Set the IPSec ESP encryption methods. You must specify at least one method.
set espintegrity [md5] [sha1] [none]
Set the IPSec ESP integrity methods. You must specify at least one method.
set ikedh [group1] [group2] [group5]
Set the IPSec IKE Diffie-Hellman groups. You must specify at least one group.
set ikeencryption [des] [3des] [blowfish] [cast]
B-10
The DHCP server IP address.
ip-address
Disable IP broadcast forwarding on all ports.
none
A space-separated list of one or more port numbers.
port-list
The ports are numbered starting at 1. A four-port
device would have ports 1, 2, 3and 4.
forwardipbroadcasts
Command Line Interface
option enabled.