Volvo XC90 TWIN ENGINE 2019 Owner's Manual page 531

1. Aim the remote control towards the
®
HomeLink button to be programmed and
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indi-
®
cator lamp on HomeLink .
Note: The ability of some remote controls
®
to program HomeLink is improved at a
distance of approx. 15-20 cm (approx.
6-12 inches). Bear this in mind if problems
occur with the programming.
2. Press and hold depressed both the button
on the remote control and the button to be
reprogrammed on HomeLink
22 Button designation and colour varies between manufacturers.
3. Do not release the buttons until the indica-
tor lamp has switched from flashing
slowly (approx. once per second) to either
flashing quickly (approx. 10 times per sec-
ond) or illuminating with a constant glow.
> If the indicator lamp illuminates with
a constant glow: Indication that the
programming has finished. Press the
programmed button twice to activate.
If the indicator lamp flashes quickly:
The device to be programmed to
HomeLink
tion that requires extra steps. Test by
®
.
pressing the programmed button twice
to see whether the programming is
working. Otherwise, continue with the
following steps.
®
may have a security func-
STARTING AND DRIVING
4. Locate programming button
receiver for the garage door or similar. It is
normally located close to the antenna's
bracket on the receiver.
5. Depress and release the receiver's pro-
gramming button once. The programming
must be completed within 30 seconds of
the button being depressed.
6. Press and release the button on
®
HomeLink that you want to program.
Repeat the sequence of pressing/holding/
releasing a second time and, depending
on the receiver model, even a third time.
> Programming is now be complete and
the garage door, gate or similar should
now be activated when the pro-
grammed button is depressed.
In the event of programming problems, con-
®
tact HomeLink at www.HomeLink.com, or
22
on the
}}
529