VTech Toot-Toot Drivers Fire Station Instruction Manual page 6

• Sticker Sheet
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child's safety.
NOTE
Please save this manual as it contains important information.
Removing the Packaging Locks:
Turn the packaging locks anticlockwise
several times.
Pull out the packaging locks and discard.
INSTRUCTIONS
Battery Removal And Installation
1. Make sure the unit is turned OFF.
2. Find the battery cover located on
the bottom of the Fire Truck, use a
screwdriver to loosen the screw and
then open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
5