Troubleshooting - Stihl HSA 130.0 R Instruction Manual

17 Troubleshooting

17 Troubleshooting
17.1 Troubleshooting Hedge Trimmer or Battery
Fault LEDs on the
battery
Hedge trimmer 1 LED flashing
does not start green.
when switched
on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs fla‐
shing red.
Hedge trimmer 3 LEDs light
cuts out during up red.
operation.
Hedge trimmer's
running time is
too short.
0458-021-9801-A
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
There is a malfunction
in the hedge trimmer.
The cutting blades do
not run freely.
Hedge trimmer is too
hot.
There is a fault in the
battery.
No electrical contact
between the hedge
trimmer and battery.
Hedge trimmer or bat‐
tery is damp.
Hedge trimmer is too
hot.
There is an electrical
fault.
The battery is not fully
charged.
Remedy
► Charge battery as described in the User
Manual for STIHL AL 101, 301, 301-4,
500 chargers.
► Pull the connecting cable plug out of the
socket.
► Allow the battery to cool down or warm
up.
► Pull connecting cable plug out of the
socket and plug it in again.
► Switch on the hedge trimmer.
► If 3 LEDs continue to flash red: Do not
use your hedge trimmer and contact your
STIHL servicing dealer for assistance.
► Spray both sides of cutting blades with
STIHL resin solvent.
► If 3 LEDs continue to flash red: Do not
use your hedge trimmer and contact your
STIHL servicing dealer for assistance.
► Pull the connecting cable plug out of the
socket.
► Allow the hedge trimmer to cool down.
► Pull connecting cable plug out of the
socket and plug it in again.
► Switch on the hedge trimmer.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
► Pull connecting cable plug out of the
socket and plug it in again.
► If the hedge trimmer still fails to start
when switched on: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's User Manual or in the
User Manual for the "AP belt bag with
connecting cable".
► Allow hedge trimmer or battery to dry.
► Pull the connecting cable plug out of the
socket.
► Allow the hedge trimmer to cool down.
► Pull connecting cable plug out of the
socket and plug it in again.
► If the hedge trimmer continues to cut out
during operation: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's User Manual or in the
User Manual for the "AP belt bag with
connecting cable".
► Switch on the hedge trimmer.
► Fully charge battery as described in the
User Manual for the STIHL AL 101, 301,
301-4, 500 chargers.
English
33