Table of Contents
Advertisement
APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
As shown, insert the tab on the needle plate
h
cover into the hole in the needle plate, and
then correctly position of the needle plate
cover.
a Needle plate cover
b Tab
c Hole
• Check that the needle plate cover is flush
with the top surface of the machine.
84
From the front, slide the needle plate cover
i
back into position.
a Needle plate cover
CAUTION
● If the needle plate cover is not flush with the
surface of the machine as shown below,
remove the needle plate cover (step
then install it again (steps
while the needle plate cover is not flush with
the surface of the machine may cause the
needle plate cover to come off of the
machine, resulting in injuries if your fingers
touch the race.
), and
d
and
). Sewing
h
i
Advertisement
Table of Contents
