Table of Contents
Advertisement
TouchPad
Description
TouchPad
TouchPad cable
Before removing the TouchPad, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery cable from the system board (see
6.
Remove the system board (see
Remove the TouchPad:
1.
Remove the three Phillips PM2.0×3.0 screws (1) that secure the TouchPad bracket to the computer, and
the lift the bracket from the computer (2).
2.
Disconnect the cable from the TouchPad (3).
3.
Remove the three Phillips PM2.0×3.0 screws (4) that secure the TouchPad to the computer, and the lift
the Touchpad from the computer (5).
Reverse this procedure to install the TouchPad.
Bottom cover on page
22).
System board on page
31).
Spare part number
928421-001
905563-001
Battery on page
23).
Component replacement procedures
33
Advertisement
Table of Contents
