Table of Contents
Advertisement
PQQX14033ZA.book 63 ページ ２００４年６月２１日 月曜日 午後４時１４分
Erasing Messages
The unit will announce the remaining recording time after playback if it is less than
3 minutes. New messages cannot be recorded when:
—"Memory full" is heard.
—"
" flashes on the base unit.
FULL
—the ANSWER ON indicator flashes rapidly (when the Answering System is on).
We recommend that you erase unnecessary messages after each playback.
Erasing a specific message
Base Unit
Press [ERASE] while the message you want
to erase is being played.
• The unit beeps, then plays back the next message.
• To exit playback mode, press [STOP] twice.
Handset
Press [
] [4] while the message you want to erase is being played.
*
• The unit beeps, then plays back the next message.
• To exit remote operation mode, press [OFF].
Erasing all messages
All recorded messages, except the greeting message, can be erased at one time.
Base Unit
Press [ERASE] while the base unit is not being used.
1
• "To erase all messages, press ERASE again" is heard.
2
Within 10 seconds, press [ERASE] again.
• The unit beeps, then announces "No messages".
• The base unit display shows "0".
Handset
Press [MENU].
1
Press Select at "Message play".
2
Press [
] [5].
3
*
• The unit beeps, then announces "No messages".
• To end remote operation, press [OFF].
• Information in the Caller List will not be erased. To erase caller information, see
page 39.
[STOP]
[ERASE]
ANSWER ON Indicator
63
Advertisement
Table of Contents
