Display Elements - Bosch GAM 270 MFL Operating/Safety Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

The numbering of the product features shown refers
to the illustration of the anglefinder/digital level on the
graphic page.
1 Fold-out leg
2 Viewing window for
display
3 Locking wheel
4 Base leg
5 Battery lid
6 Latch of battery lid
7 Display Angle measur-
ing device
8 Display Grade measur-
ing device
9 Spirit level for horizon-
tal alignment
10 Spirit level for vertical
alignment
11 Laser beam outlet
opening
The numbering of the product features shown refers
to the illustration of the anglefinder/digital level on the
graphic page.
a "H" indicator for "HOLD" memory value
b Battery indicator
c Bevel angle indicator "BVL"
d Miter angle indicator "MTR"
e Corner angle indicator "CNR"
f Spring angle indicator "SPR"
g Reading Angle measuring device
h/i Alignments arrows
j Laser operation indicator
k/m Unit of measure indicator
n Measuring value Grade Measurement
o Indicator for audio signal
Inserting/Replacing the Batteries
Use alkaline (4 x AA) batteries to operate the anglefinder/
digital level.
correct battery polarity may cause fire or personal injury.
To open the battery lid 5, press on the latch 6 and fold the
battery lid up. Insert the batteries (Fig. A).
Battery Indicator
The battery indicator b always displays the current bat-
tery status:
The battery is over 90 % full
The battery is between 60 % and 90 % full
The battery is between 30 % and 60 % full
The battery is between 10 % and 30 % full
The empty battery indicator flashes. The battery
level is under 10 %. Once the battery indicator be-
gins flashing, you can measure for approximately
another 15-20 minutes until the tool shuts down.
Always replace all batteries at the same time. Do not use
different brands or types of batteries together.
Remove the batteries from the angle finder/digital level
when not using it for longer periods. When storing for
longer periods, the batteries can corrode and self-dis-
charge.
Slide the leg extension 21 onto the fold-out leg 1 from the
front. Slide the leg extension as far as possible over the
joint of the anglefinder/digital level.
10
Features

Display elements

Assembly
Ensure polarity of each battery
matches the instructions in Fig. A. In-
Mounting the Leg Extension
12 Laser warning label
13 Serial number
14 "ON/OFF" button
15 "MTR1" button for
simple miter
16 "MTR2" button for
compound miter
17 "HOLD" button
18 On/Off button for laser
beam
19 Audio signal button
20 Calibration/change
units button
21 Leg extension
22 Protective pouch

Advertisement

Table of Contents
loading

Table of Contents