Display Elements - Bosch GAM 270 MFL Operating/Safety Instructions Manual

1.800.561.8187
Features
The numbering of the product features shown refers
to the illustration of the anglefinder/digital level on the
graphic page.
1 Fold-out leg 12 Laser warning label
2 Viewing window for 13 Serial number
display
14 "ON/OFF" button
3 Locking wheel
15 "MTR1" button for
4 Base leg
5 Battery lid 16 "MTR2" button for
6 Latch of battery lid
17 "HOLD" button
7 Display Angle measur-
ing device 18 On/Off button for laser
8 Display Grade measur-
ing device 19 Audio signal button
9 Spirit level for horizon- 20 Calibration/change
tal alignment
10 Spirit level for vertical 21 Leg extension
alignment
22 Protective pouch
11 Laser beam outlet
opening

Display elements

The numbering of the product features shown refers
to the illustration of the anglefinder/digital level on the
graphic page.
a "H" indicator for "HOLD" memory value
b Battery indicator
c Bevel angle indicator "BVL"
d Miter angle indicator "MTR"
e Corner angle indicator "CNR"
f Spring angle indicator "SPR"
g Reading Angle measuring device
h/i Alignments arrows
j Laser operation indicator
k/m Unit of measure indicator
n Measuring value Grade Measurement
o Indicator for audio signal
Assembly
Inserting/Replacing the Batteries
Use alkaline (4 x AA) batteries to operate the anglefinder/
digital level.
Ensure polarity of each battery
matches the instructions in Fig. A. In-
correct battery polarity may cause fire or personal injury.
To open the battery lid 5, press on the latch 6 and fold the
battery lid up. Insert the batteries (Fig. A).
Battery Indicator
The battery indicator b always displays the current bat-
tery status:
The battery is over 90 % full
The battery is between 60 % and 90 % full
The battery is between 30 % and 60 % full
The battery is between 10 % and 30 % full
The empty battery indicator flashes. The battery
level is under 10 %. Once the battery indicator be-
gins flashing, you can measure for approximately
another 15-20 minutes until the tool shuts down.
Always replace all batteries at the same time. Do not use
different brands or types of batteries together.
Remove the batteries from the angle finder/digital level
when not using it for longer periods. When storing for
longer periods, the batteries can corrode and self-dis-
charge.
Mounting the Leg Extension
Slide the leg extension 21 onto the fold-out leg 1 from the
front. Slide the leg extension as far as possible over the
joint of the anglefinder/digital level.
www. .com
10
simple miter
compound miter
beam
units button
information@itm.com