Toyotomi zibro RC-32 Operating Manual page 20

11 Install the wick to the wick sleeve according to the allo-
wed direction engraved on the wick sleeve.
12 Install the wick sleeve (with wick) to the primary air
tube. And then turn the wick sleeve clockwise to set in
the handle arm (the wick position should be adjusted at
No. 1).
13 Put the wick holder chassis back into position.
14 Screw the four wing nuts hand tight.
15 Place the knurled wick adjustment knob on the wick
mechanism. Turn the knob as far to the right as possi-
ble. Press the tip-over switch. Check that the wick can
be lowered completely. Repeat this check a number of
times. If the wick cannot be lowered completely it has
not been placed correctly. If this is the case, repeat the
procedure from No. 12. Pull the knurled wick adjust-
ment knob off the heater.
16 Put the cabinet back into position and tighten the three
screws. Put the knurled wick adjustment knob back into
position. Now put the combustion chamber back into
position. Check that it is level by sliding it slightly to the
left and the right by its handle. Close the grill.
17 Put the filled removable tank into position. Put the bat-
teries into the battery holder (ensure that the positive
and negative poles match the + and – marks indicated
on the battery housing). Wait 30 minutes after replac-
ing the tank and batteries before using the heater.
4
12
11a
Hole of wick
sleeve
Engraved mark
Guide pin
12a
Handle arm
13
15a
16a
16c
17a
11b
12b
14
15b
16b
16d
17b