Table of Contents
Advertisement
ENGLISH
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving parts.
u
Impairment of hearing.
u
Risk of accidents caused by the uncovered parts of the
u
rotating saw blade.
Risk of injury when changing any parts, blades or acces-
u
sories.
Risk of squeezing fingers when opening the guards.
u
Health hazards caused by breathing dust developed when
u
sawing wood, especially oak, beech and MDF.
Injuries caused by prolonged use of a tool. When using
u
any tool for prolonged periods ensure you take regular
breaks.
Noise
The declared noise emission values have been measured in
accordance with a standard test method and may be used for
comparing one tool with another.
The declared noise emission values may also be used in a
preliminary assessment of exposure.
Warning! The noise emissions during actual use of the
power tool can differ from the declared values depending
on the ways in which the tool is used especially what kind of
workpiece is processed.
Warning! Always wear proper personal hearing protec-
tion. Under some conditions and duration of use, noise from
this product may contribute to hearing loss. Be aware of the
following factors influencing exposure to noise:
Use saw blades designed to reduce the emitted noise,
u
Use only well sharpened saw blades, and
u
Use specifically designed noise-reduction saw blades.
u
Labels on tool
The following pictograms along with the date code are shown
on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear safety glasses or goggles
Wear ear protection
Wear a dust mask
Keep hands away from blade
No Hands Zone - Keep fingers and arms away
from rotational saw blades
Wear gloves when handling saw blades
12
(Original instructions)
Do not stare at operating lamp
Do not expose to rain.
Disconnect the mains plug if the cord
becomes damamged or entangled.
#
Electrical safety
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Voltage drops
Inrush currents cause short-time voltage drops. Under unfa-
vourable power supply conditions, other equipment may be
affected. If the system impedance of the power supply is lower
than 0.214 Ω, disturbances are unlikely to occur.
Using an extension cable
Always use an approved extension cable suitable for the
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely.
Use of an extension cable not suitable for the power input of
the tool or which is damaged or defective may result in a risk
of fire and electric shock.
Features
This tool includes some or all of the following features.
1. Slide bars
2. Bevel lock knob
3. Clamp lock screw
4. Work piece clamp
5. Table extension rail
6. Bolt holes
7. Mitre angle indicator
8. Kerf plate
9. Mitre lock knob
10. Base plate
11. Rotary table
12. Rear fence
13. Saw blade
14. Blade guard
15. Safety guard mounting plate
16. Motor housing
17. Saw head locking pin
Advertisement
Table of Contents
