Installations - Panasonic NN-SB636B RUH Service Manual

BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
INSTALLING
1. Empty the microwave oven and clean the inside with a
soft, damp cloth. Check for damage such as misaligned door,
damage around the door or dents inside the cavity or on the
exterior.
2. Place the oven on a counter, table, or shelf that is strong
enough to hold the oven along with food or containers that
may be placed in the unit. (The control panel side of the oven
is the heavy side. Use care when handling.)
3. Do not block the vent and the air intake openings. Blocking
the vent or air intake openings can cause damage to the
oven and may result in poor cooking results.
Make sure the microwave oven legs are in place to ensure
proper air flow.
4. Do not install the oven next to or above a conventional
surface unit or above a conventional wall oven as the heat or
steam produced by these units may damage the electronic or
mechanical parts of the unit.
5. Use microwave oven in an ambient temperature
less than 104°F(40°C).
6. Place the microwave oven on a sturdy and flat
surface at least 10 cm(4 inches) from the wall.
7. Place the microwave oven as far away as possible
from TV, RADIO, COMPUTER, etc., to prevent
interference.
INSTALLATION
10cm
GROUNDING INSTRUCTIONS
This microwave oven is designed to be used in a fully
earthed condition.
It is imperative, therefore, to make sure it is properly
grounded prior to servicing.
WARNING
THIS APPLIANCE
MUST BE GROUNDED
IMPORTANT
The wires in the line cord are colored in
accordance with the following code:
Green-and-yellow:
Blue:
Brown:
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows.
The wire which is colored green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol (
colored green or green-and-yellow.
The wire which is colored blue must be connected to
the terminal in the plug which is marked with the letter
N or colored black.
The wire which is colored brown must be connected
to the terminal in the plug which is marked with the
letter L or colored red.
3-1
Ground(Earth,E)
Neutral(N)
Live(L)
) or