Installing Transmitter Batteries - Traxxas 82044-4 Owner's Manual

If the status LED doesn't light
green, check the polarity
of the batteries. Check
rechargeable batteries for
a full charge. If you see any
other flashing signal from the
LED, refer to the chart on page
18 to identify the code.
Use the Right Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries (Part # 2914) or
rechargeable batteries,
such as NiMH (nickel-metal
hydride) batteries, in your
transmitter. Make sure
rechargeable batteries are
fully charged according
to the manufacturer's
instructions.
If you use rechargeable
batteries in your transmitter,
be aware that when they
begin to lose their charge,
they lose power more
quickly than regular alkaline
batteries.
Caution: Discontinue running
your model at the first sign of
weak batteries (flashing red
light) to avoid losing control.
2,3 2,3
14 • TRX-4 SPORT
TRAXXAS TQ 2.4GHz RADIO SYSTEM

INSTALLING TRANSMITTER BATTERIES

Your TQi transmitter uses 4 AA batteries. The battery compartment
is located in the base of the transmitter.
1. Remove the battery compartment door by pressing the tab
and sliding the door open.
2. Install the batteries in the correct orientation as indicated in
the battery compartment.
3. Reinstall the battery door and snap it closed.
4. Turn on the transmitter and check the status indicator for a
solid green light.
If the status LED flashes red, the transmitter
batteries may be weak, discharged or possibly
installed incorrectly. Replace with new batteries.
The power indicator light does not indicate the
charge level of the battery pack installed in the
model. Refer to the Troubleshooting section on page 18 for more
information on the transmitter Status LED codes.
SELECTING BATTERIES AND A CHARGER
FOR YOUR MODEL
Your model does not include a battery or charger. The speed control
in the model is compatible with both LiPo and NiMH batteries. One
NiMH or 2s/3s LiPo battery equipped with a Traxxas High-Current
Connector is required. Traxxas Power Cell iD batteries are strongly
recommended for maximum performance and safer charging.
The following chart lists all the available Power Cell batteries for
your model:
www.modellmarkt24.ch
LiPo Batteries with iD
2849X 4000mAh 11.1v 3-Cell 25C LiPo Battery
2872X 5000mAh 11.1V 3-Cell 25C LiPo Battery
2843X 5800mAh 7.4V 2-Cell 25C LiPo Battery
2869X 7600mAh 7.4V 2-Cell 25C LiPo Battery
NiMH Batteries with iD
2923X Battery, Power Cell, 3000mAh (NiMH, 7-C flat, 8.4V)
2940X Battery, Series 3 Power Cell, 3300mAh (NiMH, 7-C flat, 8.4V)
2950X Battery, Series 4 Power Cell, 4200mAh (NiMH, 7-C flat, 8.4V)
2960X Battery, Series 5 Power Cell, 5000mAh (NiMH, 7-C flat, 8.4V)
WARNING: FIRE HAZARD!
Users of Lithium Polymer (LiPo) batteries must read the
Warnings and Precautions beginning on page 4. You
MUST use a LiPo balance charger for LiPo batteries or battery
damage with the potential for fire will result.
Make certain you choose the correct type of charger for the batteries
you select. Traxxas recommends you choose a genuine Traxxas EZ-
Peak iD charger for safer charging and maximum battery life and
performance.
NiMH
Charger Part No. Compatible
EZ-Peak Plus,
2970 YES
4 amps
EZ-Peak Live,
2971 YES
12 amps
EZ-Peak Dual,
2972 YES
8 amps
EZ-Peak Live
2973 YES
Dual, 26 amps
EZ-Peak Plus 4s,
2981 YES
8 amps
LiPo Battery Max.
Compatible iD Cells
YES YES 3s
YES YES 4s
YES YES 3s
YES YES 4s
YES YES 4s