Table of Contents
Advertisement
en Home Connect
The Home Connect app guides
you through the entire login pro-
cess.
10.2 Setting up Home Con-
nect
Requirements
¡ The Home Connect app has been
installed on your mobile device.
¡ The appliance is receiving signals
from the WLAN home network (Wi-
Fi) at its installation location.
Open the Home Connect app and
1.
scan the following QR code.
Follow the instructions in the
2.
Home Connect app.
10.3 Checking the signal
strength
You should check the signal strength
if no connection could be estab-
lished.
Press and hold
1.
15 seconds.
a The temperature display (freezer
compartment) shows
Press
2.
temperature display (freezer com-
partment) shows .
a The temperature display (refriger-
ator compartment) shows a value
between
(no reception) and
reception).
20
for
.
repeatedly until the
Note: The signal strength should be
at least .
Improving the reception
If the signal strength is too weak, the
connection may be interrupted.
Carry out one of the solution op-
▶
tions:
Place the router and refrigerator
‒
closer together.
Ensure that the connection is
‒
not interfered with by screening
walls.
Install a repeater to strengthen
‒
the signal.
10.4 Installing updates for the
Home Connect software
The appliance searches for updates
to the Home Connect software at reg-
ular intervals.
Note: If updates are available, the
temperature display (freezer compart-
ment) shows
To cancel the update and reset the
temperature display (freezer compart-
ment) to the set temperature, press
any touch field.
Press and hold
1.
15 seconds.
a The temperature display (freezer
compartment) shows
Press
2.
temperature display (freezer com-
partment) shows
perature display (refrigerator com-
partment) shows
Press
3.
a The temperature display (refriger-
ator compartment) shows an anim-
ation.
a The update is installed.
(full
a The control panel is locked during
the installation.
.
for
.
repeatedly until the
and the tem-
.
.
Advertisement
Table of Contents
