EnGenius SN-902 Compact Quick Installation Manual

SN-902 Compact - Quick Installation Guide
SN901 Base Station Installation.
1. Ensure that the base station antenna is firmly connected
( anti-clockwise thread )
2. Plug the appropriate AC/DC adaptor into a standard AC power outlet,
and the other end into the "DC In" jack on the rear of the base station.
3. Plug phone cord into the "LINE" Jack.
4. A standard telephone or answering machine can be plugged into the
adjacent receptacle on the rear of the base station marked TEL.
SN902 Handset and Charger Installation.
1. Plug the appropriate AC/DC adaptor into a standard AC power outlet,
and the other end into the "DC In" jack on the rear of the Charger.
2. Install battery pack in the handset.
3. Check that the antenna is fitted.
4. Place handset onto the charger front slot.
5. Charge the battery for three hours before use.
6. After charging, the phone system is now ready for use.
Handset Registration
1. Press MENU- 6 to enter the registration mode
2. Press and hold the base's PAGE button for 3 seconds until the In Use LED (white color) lights up and is
flashing. The base station will beep to confirm that it is in the registration mode.
3. Press handset key "1", this completes the registration process. The base station will assign a handset
ID between 11 and 19 automatically. The assigned ID will be displayed on the handset LCD, indicating
successful registration.
Handset features
1.
TALK/FLASH (
a. Used to make or receive a call.
b. Sends a Flash signal to the pstn phone line to access the call waiting
feature provided by your local phone company.
c. If connected to a PBX, and during a call, pressing this button
momentarily will put the caller on hold. Pressing again will take the
caller off hold.
2.
SPEAKERPHONE (
Press and hold the key for 2-3 seconds to enable/disable the
speakerphone during incoming, outgoing or intercom call.
3. 2-WAY INTERCOM (
)
)
)
1
English