Storage; Troubleshooting - Bosch MUM59N26CB Instruction Manual

en

Storage

Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on a
cloth and rub the film off the continuous­
feed shredder (not the cutting discs). Then
rinse the continuous­feed shredder.
Cleaning the blender
W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands.
The blender jug, lid and funnel are
dishwasher­proof.
Tip: After processing liquids, it is often suffi­
cient to clean the blender without removing
it from the appliance. Pour 700 ml of water
and a drop of washing­up liquid into the
attached blender. Switch on the blender
for aproximately 1 minute (setting 7). Pour
out the water and rinse out the blender with
clear water.
Important information
If required, clean accessories bag. Follow
care instructions in the bag.
Storage
W Risk of injury!
When the appliance is not in use, pull out
the mains plug.
Figure K:
■ Store tools and cutting discs in the
accessories bag.
■ Keep accessories bag in the bowl.

Troubleshooting

W Risk of injury!
Before eliminating a fault, pull out the mains
plug.
Note:
The Operating indicator flashes if the
appliance has been operated incorrectly
or the electronic fuse has tripped or the
appliance is defective.
The swivel arm must be engaged in
every operating position.
30
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Troubleshooting
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check swivel arm. Correct position?
Engaged?
■ Screw on blender or bowl as far as
possible.
■ Attach the blender cover and screw on
as far as possible.
■ Attach drive cover to unused drives.
■ The safety lock is active. Switch
appliance to 0/off and then back to the
required setting.
Troubleshooting
Appliance switches off during use. The
overload protection feature has been
activated. Too much food was processed
at one time.
Remedial action
■ Switch off the appliance.
■ Reduce processing quantity.
Troubleshooting
While the drive was running, the release
button was inadvertently pressed. The
swivel arm moves up. The drive switches
off, but does not stop in the tool change
position.
Remedial action
■ Set the rotary switch to 0/off.
■ Move swivel arm to position 1.
■ Switch on appliance (setting 1).
■ Switch off appliance again.
Tool stops in tool change position.
Troubleshooting
Blender does not start working or stops
during use, the drive is "humming". Blade
is blocked.
Remedial action
■ Switch off the appliance and pull out the
mains plug.
■ Detach the blender and remove the
obstruction.