Advertisement
9.
Go to "Color/Brightness Control" and use "Output Fade" to select the MIDI message that
controls the fade applied to the video mixer's final video output.
(Controls are not accepted via MIDI when this is set to [OFF].)
The fade applied to the video mixer's final video output is controlled by the selected MIDI message.
The range of MIDI values, 0–64–127, corresponds to the range of the minimum to maximum values
for the parameter.
You can use the box on the right side to select the polarity of the control. Select "+" to set the parameter
targeted for MIDI control to [0: normal playback – 64: 50% white fade – 127: 100% white fade], "-" for
[127: 100% black fade – 64: 50% black fade – 0: normal playback], and "+/-" for [-127: 100% black fade
– 0: normal playback – 127: 100% white fade].
Some video mixers may not support this feature.
This setting is shared with "Controlling Fades" (p. 94).
10.
To set the latency between the PR-80 and the video mixer, use the "Presenter => External
Latency" and "External => Presenter Latency" settings.
The latency (delay) for operations made from the PR-80 may differ from one video mixer to another.
If video transitions under control from the PR-80 are corrupt, or if unexpected video is seen during
such transitions, then adjust these two values to make video transitions smooth. Delay can also be
applied to input switching on the video mixer, so adjusting this may also be a good idea.
(For information on the V-4 and the V-440HD, refer to "Setting Examples for Edirol Video Mixers".)
11.
Select the "Video Mixer Control" check box.
This enables the Video Mixer Control feature.
12.
Click the [Done] button.
For more details about operating the video mixer, refer to the owner's manual that came with the
video mixer.
Presenter's output-fade and effects cannot be controlled with MIDI while the Video Mixer Control
feature is on.
If you find the controls are not working well, try turning off the control feature (clearing the check
box) and turning it on again (selecting the check box once more).
Set "Output Fade"
Set "Presenter => External Latency"
Set "External => Presenter Latency"
Mark the checkbox
Advertisement
