• Be careful not to scratch the rear frame when
disassembling/re-assembling or when tightening the
screws.
• Make sure the Shield Plate is placed properly.
• The Function CBA Unit and Sensor Lens are fixed in
place by the hooks. Make sure these hooks are not
damaged. Make sure the Function CBA Unit and
Sensor Lens are securely in place when
re-assembling.
• The screw tightening torque must be 6.1lbf·in
• Make sure the tact switches operate normally after
• Make sure to replace the Control Plate to a new one
(S-3)
[1] Stand Assembly
4-2
(7kgf·cm).
replacing the Front Cabinet, Function CBA Unit,
Sensor Lens, or Shield Plate.
when replacing the Front Cabinet.
[2] Rear Cover
(S-1)
(S-3)
(S-2)
Fig. D1
PL13.10_DC