Attaching The Hoop - Bernina 720 User Manual

Embroidering preparation
> Place the template in the inner hoop, so the BERNINA logo is at the front edge at the arrow mark until it
> Place the material under the inner hoop.
> Line up the marked center point on the center of the template.
> Place the material and the inner hoop on the outer hoop so that the arrows of both hoops match.
> Fit the hoops into each other; ensure that the material does not move.
> Hoop the fabric to be embroidered tightly.
> Tighten the screw.
> Remove the template from the hoop by using the template holder.
> To avoid scratches on the free arm, press the inner hoop into the outer hoop so that the inner hoop

Attaching the hoop

> Raise the needle.
> Raise the embroidery foot.
> Hold the hoop with the right side of the fabric up with the attaching mechanism to the left.
> Position the hoop below the embroidery foot.
> Press both attaching mechanisms (1) of the hoop towards each other.
> Position the embroidery hoop (2) above the bracket of the embroidery arm.
> Press the hoop down until it clicks in position.
> Release the attaching mechanism (1).
> Press the attaching mechanisms of the hoop towards each other to remove the hoop.
> Remove the hoop.
138
clicks into place.
including the fabric protrudes downwards by up to 1 mm.
2
1
1