Table of Contents
Advertisement
Button Names and Functions
11. Foot Switch
You can connect an optional foot switch (such as the FS-5L)
to obtain pedal control over a variety of different functions.
TIP:A/B and RING:MANUAL Jack
You can use a foot switch to switch between memory A and
memory B or switch the Manual function on and off.
fig. 3 (explanatory figure)
WHITE
TIP :
A/B
RING:
MANUAL
RED
TIP:
Switches between memory A and memory B.
RING: This switches the Manual function on and off. When
switched off, the settings of the memory just selected
are used.
(When using the FS-5L)
When the polarity switch is set as shown in the
figure above the FS-5L's indicator lights up when
the DB-900 is switched to Manual.
When using a stereo connection cord (PCS-31 etc.), be
NOTE
sure to use two foot switches. Use with one plug empty
may result in unstable operation.
When a foot switch is connected to this jack, the
NOTE
MANUAL, MEMORY A, and MEMORY B
buttons do not function.
If you use a mono connection cord to connect a foot
NOTE
switch, you'll only be able to use it to switch between
Memory A and B.
10
Switch between Memory A
and MemoryB
Polarity
switch
Manual function ON/OFF
CHORUS jack
This lets you switch the chorus effect on and off.
(When using the FS-5L)
Set the polarity switch as shown in the diagram
below. With this setting, the indicator of the FS-
5L will light when the Chorus effect is on.
fig. 4 (explanatory figure)
CHORUS
When the D-chorus INTENSITY knob setting is
NOTE
made or stored while at "OFF," the foot switch cannot
be used to switch chorus on or off.
If the D-chorus INTENSITY knob has been used to
NOTE
turn on the Chorus effect, using the foot switch to turn
off the Chorus effect will cause the D-CHORUS
indicator to blink.
Polarity
switch
Advertisement
Table of Contents
