Piecing - Brother 882-D30 Operation Manual

SEWING THE STITCHES
Stitch Stitch name
Rick-rack stitch
Decorative stitch
Decorative stitch
Hemstitching
Hemstitching
Single diamond
overcast
Overcasting stitch
Piecing stitch (Right)
Piecing stitch (Middle)
Piecing stitch (Left)
Hand-look quilting
Quilting appliqué zigzag stitch
Quilting appliqué stitch
Quilting stippling
Memo
• When a stitch pattern in the Quilting
Stitches category (Q-02 through Q-30) is
selected, a finer stitch width can be set than
is available with stitch patterns in other
categories.
For example: Stitch Q-03 has 57 needle
positions and stitch Q-19 has 29 width
selections.
S-36
Presser foot
Note
• The width range of stitch setting is only

■ Piecing

Sewing two pieces of fabric together is called
piecing. When cutting pieces for quilt blocks, make
sure the seam allowance is 6.5 mm (approx.
1/4 inch).
a
Select
"J".
b
Align the edge of the fabric with the edge of
the presser foot, and start sewing.
* To sew a 6.5 mm (approx. 1/4 inch) seam allowance
along the right edge of the presser foot with
selected, the width should be set to 5.50 mm
(approx. 7/32 inch).
a 6.5 mm (approx. 1/4 inch)
* To sew a 6.5 mm (approx. 1/4 inch) seam allowance
along the left edge of the presser foot with
selected, the width should be set to 1.50 mm
(approx. 1/32 inch).
a 6.5 mm (approx. 1/4 inch)
* To change the needle position, use
the width display.
available in the Quilting stitch "Q" quilting
category.
or and attach presser foot
or in