Advertisement
3.
Attach the crank cam and crank cam holder to the blade (Fig. 15)
The same type of crank cam holder is used in the shrub shear and the grass shear. Use the
crank holder installed in the product.
Crank cam holder
Crank cam (A)
Blade case
4.
Attach the new blade
(1)
Align the pin on the tool with the
center hole in the crank holder.
(Fig. 16)
(2)
When the hexagonal part in the crank
holder and the grooves in the gear do
not align, fi ne adjust so that the crank
holder aligns with the gear grooves.
(Fig. 17)
(3)
Turn over the tool making sure that the blade does not fall
out, attach the bottom plate and secure it with the 4 screws.
(Fig. 18)
NOTE
Be sure to check blade operation after it has been attached.
The blade and the crank cam has not been properly fi tted if the
blade does not operate correctly. Do the instructions over from
the beginning.
HOW TO USE
WARNING
○
To prevent accidents, make sure there are no people in the work area.
○
Keep your hands and all parts of the body away from the blade to prevent contact
that could lead to injury.
○
Use protective goggles during work to prevent injury from twigs and wood chips.
○
Do not use to tool to cut wire, metal plates or other hard objects. The tool could be
damaged and cause injury.
Blade cover
Blade
Fig. 15
41
Crank cam holder
Crank cam (B)
Blade
Pin
Crank cam holder
Center hole
Fig. 16
English
Fig. 17
Screw
Bottom
plate
Fig. 18
Advertisement
