Coolant - Yamaha XMAX 125i 2005 Owner's Manual

Tightening torque:
Final transmission oil drain bolt:
20 Nm (2.0 m•kgf, 14.5 ft•lbf)
6. Add the specified amount of the
recommended final transmission
oil, and then install and tighten
the oil filler cap.
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.21 L (0.22 US qt) (0.18 Imp.qt)
s WARNING
s
Make sure that no foreign
material enters the final trans-
mission case.
Make sure that no oil gets on
the tire or wheel.
7. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.
PERIODIC MAINTENANCE AND MINOR REPAIR

Coolant

The coolant level should be checked
before each ride. In addition, the coo-
lant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level surface
and hold it in an upright position.
NOTE:
EWA11310
The coolant level must be chec-
ked on a cold engine since the
level varies with engine tempera-
ture.
Make sure that the vehicle is
positioned straight up when
checking the coolant level. A
slight tilt to the side can result in
a false reading.
EAU20070
EAUS1270
1. Maximum level mark
2. Minimum level mark
2. Check the coolant level through
NOTE:
The coolant should be between the
minimum and maximum level marks.
1
1. Coolant reservoir cap
6-11
the check window.
6