Wet/Dry Vac Assembly - RIDGID WD1450 Operator's Manual

SP6542-2.qxd 6/26/07

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caster foot assembly as
shown (assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum
1:20 PM Page 9
Drum
Latch
Drum
Flange
9
Insert Hose
Insert the push button end of the "Tug-A-
Long" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Press
and
Pull
Release
Button