Table of Contents
Advertisement
AutoDome 100 Series Fixed Camera
8.
9.
4.6.2
Interface Box Connections
The following figure is a detailed illustration of the In-ceiling Interface box.
Figure 4.8 In-ceiling Interface Box
1
2
3
4
Bosch Security Systems, Inc.
To connect supervised alarms and relays, attach the appropriate wires to their terminals
on the P104 connector on the Pipe Interface Board. Refer to Section 6 Alarms and Relay
Connections, page 69 for more details on wiring alarms.
Attach the lid to the Interface box:
a.
Align the slots on the lid with the two posts at the rear of the Interface box.
b.
Rotate the lid down.
c.
Squeeze the ground clips, located at the front of the box, against the Interface box
with your fingers before closing the lid to ensure that the lid does not catch on the
ground clips.
d.
Secure the lid to the Interface box by pushing the lid down until the clip on the lid
catches against the box.
Fiber Optics
UTP/Ethernet Video
(Ethernet for VG5 700 Series only)
Dome Power
Data In/Out
Installation Manual
Installing the In-Ceiling Mount | en
5
Coax Video
6
Alarm In
7
Analog In
8
Relay
57
F.01U.217.818 | 1.0 | 2011.04
Advertisement
Table of Contents
