Part Name: 1 – inner drain hose 2 –check plate assembly
3.
Pull out check plate from check plate holder, and replace a new check plate.
4.
Reverse the above procedure to install. And check out all connectors connects well.
Inlet valve
Removal and Replacement
1.
Remove cover of bottom board. (see main control board removal and replacement)
2.
Pull out all terminals of inlet valve.
3.
Remove clamp for fixing connecting hose to inlet valve, and contrarotate inlet valve to take it
out.
4.
Reverse the above procedure to install. And check out all connectors connected well.
Operating board
Removal and Replacement
1. Disconnect power supply.
2. Remove all screws for fixing control panel. (see control panel removal and installation)
3. Put out all housings for connecting operating board.
4. Remove screw and unfix all snaps for fixing the operating board. (see control panel
removal and installation)
5. Reverse the above procedure to install. And check out all connectors connected well.
1
2
Clamps
Terminals
12