Cobra 06-0225-01B Instruction Manual

Items Supplied >
1 – INTAKE COVER W/ SCREEN / RING ASSEMBLY
1 – K&N® VENTURI AIR FILTER
1 – BILLET VELOCITY STACK
1 – MOUNTING PLATE
1 – SUPPORT BRACKET
2 – BOLT, M5 X 16mm, ALLEN
1 – BOLT, M5 X 30mm, ALLEN
7 – BOLT, 1/4"-20 X 1/2", BUTTONHEAD
4 – WASHER, 1/4" INTERNAL TOOTH LOCK
1 – WASHER, M5 SPLIT LOCK
1 – O-RING, 1.25"I.D. X .125", BUNA-N (SMALL)
1 – O-RING, 3.25"I.D. X .125", BUNA-N (LARGE)
Instruction Manual >
Read all instructions carefully and completely before installing your new POWRFLO
1. Remove the (4) bolts that hold on the stock air cleaner cover. Remove chrome cover and filter from air box.
2. Remove the air box by loosening the (3) allen bolts around the air inlet and the (1) M6 hex nut from the lower
portion of the air box. See Figure 1. Disconnect the hose from the backside of the air box.
3. Insert the supplied o-rings into the grooves of the supplied velocity stack. NOTE: Do not attempt to stretch o-rings
into grooves; position o-rings evenly around groove and use gentle force (No tools) to push them in.
4. Bolt the velocity stack to the throttle body using the (2) supplied M5 x 16mm allen bolts and the (1) supplied M5 x
30mm allen bolt w/ split lock washer. Fully tighten. See Figure 2.
5. Position the mounting plate over the velocity stack (with the welded tube toward inside) and secure using (3)
supplied 1/4"-20 x 1/2" buttonhead bolts and (3) internal tooth lock washers, finger tighten only. See Figure 3.
6. Remove the bracket which holds the bolt that secured the M6 hex nut in Step 2. Using the two allen bolts (just
removed), install the supplied support bracket. Then secure the support bracket to the mounting plate using the
(1) 1/4" buttonhead bolt and internal tooth lock washer. See Figure 3 & 4.
REMOVE (3)
ALLEN BOLTS
FIGURE 1
* Cobra recommends you always wear a helmet while riding. Please never operate your motorcycle while under
®
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
DOCUMENT NO. 0017 REV. A
01/14
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016
®
(2) SUPPLIED M5 X 16mm
REMOVE HEX NUT SUPPLIED M5 X 30mm ALLEN BOLT
& BRACKET
(
BEHIND AIR BOX)
1
Application(s) >
YAMAHA V-STAR 950
06-0225-01B / 02B / 03B / 04B
VELOCITY
STACK
ALLEN BOLTS
w/ SPLIT LOCK WASHER
FIGURE 2
www.cobrausa.com
2007 - 2014
Page 1 of 2
TM
Intake.
LARGE O-RING
(ACTUALLY ROUND)
SMALL O-RING
(ACTUALLY ROUND)
®