Unpack And Remove The Cover Of The Appliance - Bosch Tronic 4000 Series Installation And Operating Instructions Manual

Installation (only for approved contractors)
Electrical connection Protection
rating (PR)
Upper connection IP25
(Fig. 35)
Lower Connection IP25
(Fig. 36)
Lower connection with IP23
individual cables
(Fig. 37)
Table 4
Fig. 8
[0] Protection zone 0
[1] Protection zone 1
[2] Protection zone 2
[2*] Without the wall, protection zone 2 must extend to
600 mm away from the bath
[A] 600 mm radius from the bath or shower
5.3

Unpack and remove the cover of the appliance

NOTICE
Risk of damage to the appliance!
In the event of transportation damages,
▶ Do not install the appliance.
Before carrying out any installation,
▶ Pay attention to the instructions given in this manual.
▶ Perform the installation of the appliance according to the
following images.
▶ Unpack the appliance.
12
▶ Dispose of the packaging according to the recycling
Permitted
protection zone
▶ Remove the front fascia of the appliance.
Zone 1 and higher
Zone 1 and higher
Outside of Zone 2
Fig. 9
▶ Loosen the fixing screw at the front of the appliance.
Fig. 10
systems applicable in the country.
Remove the front fascia
Remove the screw
Tronic 4000 – 6721830066 (2021/06)