Contrast; Pop-Up Pilot; Remote Control - Raymarine ST60 Owner's Handbook Manual

6
2. There are four preset illumination levels. Press the speed key to cycle through
these levels until you reach the level you want.
3. Press any other key to leave the illumination-adjust mode.
The display will time out to normal operation 7 seconds after the last key press.
Note:

Contrast

To adjust the display contrast:
1. Hold down the speed key for approximately two seconds, to enter the con-
trast-adjust mode.
2. There are four preset contrast settings. Press the speed key to cycle through
these settings until you achieve optimum display quality.
3. Press any other key to leave the contrast-adjust mode.
The display will time out to normal operation 7 seconds after the last key press.
Note:

1.4 Pop-up Pilot

A Pop-up Pilot facility enables instruments connected to SeaTalk to constantly
monitor any changes to the autopilot mode and to the course settings. If one of
these parameters changes, the new value is immediately displayed on the ST60
instrument for 5 seconds, after which time the display reverts to the previous
display.
This facility can be enabled or disabled during User calibration (see
Calibration

1.5 Remote control

When connected to SeaTalk, the ST60 Speed instrument can be controlled
remotely with a SeaTalk Remote Keypad Unit. Remote control of an instrument is
indicated by a REMOTE legend on the display, to indicate that the keypad has
control.
Details on how to use the remote control facility can be found in the
Remote Keypad Owner's Handbook
).
ST60 Speed Instrument Owner's Handbook
.
Chapter 4,
SeaTalk