Securing Cables And Replacing Cover; Fitting Speed, Depth & Wind Transducers; Speed & Depth; Running Transducer Cable - Raymarine ST290 Owner's Handbook Manual

Chapter 2: Installation Procedures
NMEA2000
Table 2-5: NMEA2000 Transmitted data
Parameter Group Number Data
128259
127250
128267
130306
130310

Securing cables and replacing cover

When the DPU cables have all been connected, secure each cable to the
loops on the DPU, using the cable ties provided.
When all cables are secure, replace the DPU cover.
Do not use the DPU with the cover removed, as this could degrade the
EMC performance.
2.5 Fitting Speed, Depth & Wind transducers
Each transducer connects to SeaTALK
with the transducer. These instructions describe how to fit the transducers
and run the transducer cables to the intended locations for the Pods. At
each Pod location, leave at least 2 ft (600 mm) of transducer cable, to
facilitate future connection.
Speed & Depth
Instructions for installing and maintaining the Speed and Depth
transducers are packed with the transducers. Install these transducer
types in accordance with these enclosed instructions.

Running transducer cable

Speed and Depth transducers each have a 45 ft (13.7 m) cable, which
connects to the relevant Pod. Observing the guidelines given under Cable
routing guidelines near the start of this chapter, run the cable to the
intended location for the Pod.
ST290 Instrument System Owner's Handbook
SOG and water speed
Magnetic heading, deviation and variation
Water depth
Wind speed and direction
Water temperature
2
via a dedicated Pod, supplied
6-2-11