JVC KD-HDR41 Instructions Manual page 13

Menu item
L/O MODE
5
SUB.W LPF *
5
SUB.W LEVEL *
HPF
BEEP
TEL MUTING *
7
AMP GAIN *
8
SSM *
AREA
8
MONO *
BLEND HOLD *
IF BAND
9
AM *
9
F-AUX *
9
R-AUX *
5
* Displayed only when <L/O MODE> is set to <SUB.W>.
6
* This setting does not work if <BT ADAPTER> is selected for <R-AUX> of the <SRC SELECT>.
7
*
The volume level automatically changes to "VOLUME 30" if you change to <LOW POWER> with the volume level set
higher than "VOLUME 30."
8
* Displayed only when the source is "FM" or "AM."
9
* Displayed only when any source other than "AM/ F-AUX/ R-AUX/ BT AUDIO" is selected separately.
Selectable setting, [Initial: Underlined]
SUB.W : Selects if the REAR/SW terminals are used for connecting a subwoofer
(through an external amplifier). / REAR : Selects if the REAR/SW terminals are used for
connecting the speakers (through an external amplifier).
LOW 55Hz / LOW 85Hz / LOW 120Hz : Frequencies lower than
55 Hz/85 Hz/120 Hz are sent to the subwoofer.
00 — 08 [ 04 ] : Adjusts the subwoofer output level.
ON : Activates the High Pass Filter. Low frequency signals are cut off from the front/rear
speakers. / OFF : Deactivates (all signals are sent to the front/rear speakers).
ON / OFF : Activates or deactivates the keypress tone.
6
ON : Mutes the sounds while using the cellular phone (not connected through
KS-BTA100). / OFF : Cancels.
LOW POWER : VOLUME 00 – VOLUME 30 (Selects if the maximum power
of each speaker is less than 50 W to prevent damaging the speakers.) /
HIGH POWER : VOLUME 00 – VOLUME 50
See page 8.
US : When using in North/Central/South America. AM/FM intervals are set to
10 kHz/200 kHz. / EU : When using in any other areas. AM/FM intervals are set to
9 kHz/50 kHz. / SA : When using in South American countries where FM interval is
50 kHz. AM interval is set to 10 kHz.
See page 8.
8
See page 8.
AUTO : Increases the tuner selectivity to reduce interference noises between adjacent
stations. (Stereo effect may be lost.) / WIDE : Subject to interference noises from
adjacent stations, but sound quality will not be degraded and the stereo effect will
remain.
ON / OFF : Enable or disable "AM" in source selection.
ON / OFF : Enable or disable "F-AUX" in source selection.
ON / OFF : Enable or disable "R-AUX" in source selection. / BT ADAPTER : Selects
if the rear auxiliary input jack is connected to the Bluetooth adapter, KS-BTA100 (page
10.) The source name changed to "BT AUDIO."
ENGLISH 13