Advertisement
Operating Instructions
Adjusting Tool
1. Determine if a moderate or large amount
of leverage for the job is needed.
Figure F: Adjusting Shaft
2. Loosen Lock Pin (17) by turning it as
shown in Figure F. This allows adjustment
to length of the Shaft (18)
Item 59766
Shaft (18)
Lock Pin (17)
For technical questions, please call 1-888-866-5797.
3. Adjust length of the Shaft to suit needs. If a large
amount of leverage is needed for your press
job, lock the Shaft in the extended position.
If a moderate amount of leverage is needed,
position the Shaft in the middle of the Gear.
4. Tighten the Lock Pin to secure Handle. The
following steps show Shaft in extended position.
Page 7
Advertisement
