GTG25 F120-5/8
Pos.
Item
Service tool
Recommended torque
Item
Note
1
Flap disk
Type
Hole diameter
Peripherical speed
2
Nut locking the flap disk
Service tool
Recommended torque
3
Locking kit
Service tool
Recommended torque
Lever assembly options
WARNING Risk of injury
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply when not
►
in use, before changing accessories or when making repairs.
Always wear protective gloves when changing accessories or when making repairs.
►
1.
Remove the lever by using a screwdriver.
2.
Remove the two screws that holds the release holder.
EN
© Atlas Copco Industrial Technique AB - 9839 0590 01
Backing pad
Hex key 4 mm
15 Nm
Application:
Flap disk
Ø 125 mm, 5"
D1
22 mm
80 m/s
Ø 41 mm
Face spanner cc 30 × 5.5
15 Nm
Hex key 4 mm
15 Nm
Operation
13