Table of Contents
Advertisement
MAINTENANCE
CLEANING THE BRUSHROLL
Using a coin, turn locks counterclockwise to
open, then lift off cover to access brushroll.
Clear blockages from airway. Replace
cover, pressing down firmly on all sides
before turning locks clockwise to close.
CORD MAINTENANCE
To minimize the risk of power cord damage, DO
NOT run the vacuum over the power cord. If this
occurs, immediately shut off power to the vacuum
and remove the cord from the brushroll or nozzle.
s h a r kc l e a n . c o m
Squeeze tabs together and pull up
to expose the airway.
Use scissors to remove any string,
carpet fibers, or hair that is wrapped
around the brushroll.
1.
DO NOT pull or carry vacuum cleaner by the
cord or use cord as a handle.
2.
DO NOT unplug by pulling on the cord. Grasp
the plug, not the cord.
3.
DO NOT close the door on the cord.
4.
DO NOT pull the cord around sharp corners.
5.
DO NOT leave the cord near heated surfaces.
CHECKING FOR BLOCKAGES
POD BLOCKAGES
Detach hose from vacuum pod, and check hose
and opening on back of pod for blockages.
NOZZLE BLOCKAGES
Detach pod from floor nozzle, tilt nozzle neck
back, and check opening for blockages.
DUST CUP BLOCKAGES
Detach dust cup from vacuum pod. Empty dust
cup, remove debris from lint screen, and check for
blockages.
WAND BLOCKAGES
Detach wand from floor nozzle and handle, and
check both ends for blockages.
HANDLE/HOSE BLOCKAGES
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
s h a r kc l e a n . c o m
Advertisement
Table of Contents
