Safety Instructions - MSI Optix G27C7 Manual

Safety Instructions

∙ Read the safety instructions carefully and thoroughly.
∙ All cautions and warnings on the device or user's manual should be noted.
∙ Refer servicing to qualified personnel only.
∙ Keep the User's Guide that comes with the package for future reference.
∙ To prevent fire or shock hazard, keep this device away from humidity and high
temperature.
∙ Lay this device on a reliable flat surface before setting it up.
∙ Make sure that the power voltage is within its safety range and has been adjusted
properly to the value of 100~240V before connecting the device to the power outlet.
Do not disable the protective earth pin from the plug. The device must be connected
to an earthed mains socket-outlet.
∙ Always disconnect the power cord or switch the wall socket off if the device would be
left unused for a certain time to achieve zero energy consumption.
∙ The ventilator on the device is used for air convection and to prevent the device from
overheating. Do not cover the ventilator.
∙ Do not leave the device in an unconditioned environment with a storage temperature
above 60℃ or below -20℃, which may damage the device.
∙ NOTE: The maximum operating temperature is around 40℃.
∙ When cleaning the device, be sure to remove the power plug. Use a piece of soft
cloth rather than industrial chemical to clean the device. Never pour any liquid into
the opening; that could damage the device or cause electric shock.
∙ Place the power cord in a way that people are unlikely to step on it. Do not place
anything on the power cord.
∙ Always keep strong magnetic or electrical objects away from the device.
∙ If any of the following situations arises, get the device checked by service personnel:
• The power cord or plug is damaged.
• Liquid has penetrated into the device.
• The device has been exposed to moisture.
• The device does not work well or you can not get it work according to user's
manual.
• The device has dropped and damaged.
• The device has obvious sign of breakage.
∙ To prevent the monitor from tipping over, secure the monitor to a desk, wall or fixed
object with a anti-tip fastener that helps to properly support the monitor and keep it
safe in place.
⚠
Important
Please confirm the power distribution system in the installation site shall provide the
circuit breaker rated 120/240V, 20A (maximum).
21
Safety Instructions