Chamberlain 895MAX Manual

Can be used as a replacement remote control for 80
Series, 970 Series, and 370 Series LiftMaster remote
controls.
Compatible with 315 MHz or 390 MHz garage door
openers manufactured after January 1, 1993. Make
sure the garage door opener has a working light bulb
because it is a programming indicator.
For use with gate operators, commercial door
operators, or other products that are 315 MHz or 390
MHz and have a Learn button. Refer to your product
manual for the location of the Learn button.
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer or birth defects
or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PREPARE
PROGRAMMING THE REMOTE CONTROL
1
Press and hold the program button
the remote control until the LED on
the front of the remote control turns on.
890MAX
893MAX
Visor Clip
895MAX
4
Press and release the Learn
button on the garage door
opener.
Learn
Button
The Learn LED will light.
Within 30 seconds...
MODEL 895MAX
MODEL 893MAX
MODEL 890MAX
OR
Learn
LED
Learn
LED
Green
or
Purple
Red/Orange
2
Press and release the remote control
button you wish to use the number of
times that corresponds with the garage
door opener type:
# of Presses
1
2
3
4
Safety Pin or
Paper Clip
5
Press the remote control button
programmed in step 2 until the
garage door opener lights flash
or two clicks are heard.
MODELS 890MAX, 893MAX, AND 895MAX
LEDs
LED
LED
Locate the Learn
button on the garage
door opener.
NOTE: Your garage door
opener may look different.
OR
Learn
LED
Yellow
Garage Door Opener Type
Security+ 2.0 TM (Yellow Learn Button)
315 MHz Security+ ® (Purple Learn Button)
390 MHz Security+ ® (Red/Orange Learn Button)
390 MHz Billion Code (Green Learn Button)
6
To test, press the programmed
button on the remote control...
3-BUTTON REMOTE CONTROLS
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate or play with remote controls.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted and there
are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
Locate the Program button on
the remote control.
Program Button
893MAX
3
To exit programming mode,
press any remote control button
except the button that was just
programmed.
7
Install the visor clip
(not applicable for
Model 890MAX).
The garage door
opener will activate.
890MAX
895MAX