Bosch NIT5469UC/01 Use And Care Manual page 20

Display
"‰
"Š‹‹‹
"Š‹‚‹
"Š‹‚‚
Do not place hot pans on the control panel.
Notes
If " appears on the display, the sensor for the element
▯
in question must be held down in order to be able to
read the fault code.
If the fault code is not listed in the table, disconnect
▯
the cooktop from the power supply, wait 30 seconds,
and then reconnect it again. If the display appears
again, contact Customer Support and tell them the
precise fault code.
If a fault occurs, the appliance will not switch to
▯
standby mode.
Suitability test of cookware
This function can be used to check the speed and quality
of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the element being used.
With the cookware still cold, fill it with approx. 8 oz.
1.
(200 ml) of water and place it on the center of the
cooking zone with the diameter that most closely
matches the base of the cookware.
Go to the basic settings and select the
2.
Touch the settings range.
3.
zone display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear on the cooking zone
display.
20
Possible cause
The element was operating for an
extended period without interruption.
The supply voltage is incorrect; out-
side of the normal operating range.
The cooktop is not connected prop-
erly.
setting.
™‚ƒ
A will flash on the cooking
Solution
The automatic safety switch-off function has been
activated. See section "Automatic time limitation"
Contact your electrical utility provider.
Disconnect the cooktop from the power supply.
Ensure that it has been connected in accordance
with the connection diagram.
Check the result using the table below:
Result
The cookware is not suitable for the element and
‹
will therefore not heat up.*
The cookware is taking longer to heat up than
‚
expected and the cooking process is not going as
well as it ought to.*
The cookware is heating up correctly and cooking
ƒ
is progressing well.
* If there is a smaller element available, try the cook-
ware again on the smaller element.
To reactivate this function, touch the settings range.
Notes
If the diameter of the used cooking zone is much
▯
smaller than the diameter of the cookware, only the
middle of the cookware can be expected to heat up.
This may result in the cooking results not being as
good as expected or being less than satisfactory.
You can find information on this function in the section
▯
~ "Basic settings"
You can find information on the type, size and
▯
positioning of the cookware in the section
~ "Cooking with Induction"