Remote Control Batteries - Danby DAC060BHUWDB Owner's Manual

OPERATING INSTRUCTIONS
REMOTE CONTROL
1. Mode Button: Used to choose the operating
mode.
2. Energy Saver Button: Used to set the energy
saver function.
3. Up and Down Arrows: Used to adjust the set
temperature in 1° increments and the timer
function in 30 minute increments up to 10 hours
and then in 1 hour increments up to 24 hours.
4. Default Button: Press to restore the remote
control default settings.
5. Lock Button: Press this button to lock the remote
control and prevent the settings from being
inadvertently changed.
6. Sleep Button: Used to set the Sleep function.
7. LED Button: Press to turn the LED back light on
or off.
8. Clock Button: Press and hold the button for
3 seconds in order to set the clock. Press the
Up and Down Arrows to adjust the time in 10
minute intervals
Note: The clock feature is only available on the
remote, the appliance does not have a clock. The
remote clock is a 24 hour clock only.
9. Cancel Button: Cancels current Timer settings.
10. Timer Button: Used to set the auto on and auto
off timer.
11. Fan Button: Used to set the fan speed. The fan
can be set to Low, Medium, High and Auto.
1
2
6
11
10
3
9
4 5
8
7

REMOTE CONTROL BATTERIES

The remote control requires two AAA alkaline
batteries (included). Batteries should be replaced
when:
a) No sound is heard when attempting to program
the appliance.
b) The appliance does not respond to a command
issued by the remote control.
Battery replacement:
1. Slide the rear cover on the remote in the
direction of the arrow.
2. Insert two AAA batteries following the same
orientation depicted inside the battery chamber
(+/-).
3. Reinstall the rear cover.
4. If the remote control will not be used for
extended periods of time, the batteries should be
removed.
Notes:
• Protect the remote control from high
temperatures, and keep it away from radiation
exposure.
• Keep the control panel receiver out of direct
sunlight.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh,etc) batteries.
• The remote operates within a range of 8 meters
(26 ft.) from the receiver located inside the main
appliance. Any obstruction between the receiver
and remote may cause signal interference,
limiting the ability to program the main unit.
6