Hunter 51019 Installation Manual page 9

1
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
To install the shade, first loosen
the thumb screws. Raise the
shade to the light fixture. Tighten
all thumbscrews securely.
Repeat x3
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket Downrod
2
Partially install two of the switch housing
screws found in the
Align the notches in the sides of the lower
switch housing with the screws on the
upper switch housing. Twist the lower
switch housing clockwise to lock into place.
Installing the Bulbs and Glass
and click "How do I install my
Hanging Fan Wiring
Assembling the Light
2 of 3
Switch Housing
Screw
bag
hardware bag.
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
Canopy
3
bag
Install the last light switch housing
screw. Tighten all three screws securely.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Note:
Blades Light
1886
1 of 3
Switch Housing
Screw
ON
Fan style may vary.
8
Glass/Bulbs