Zenoah FMZ1200 Operator's Manual page 15

Maintenance
Examine and do a test of the brakes
Do a check of the engine oil level
Do a check of the battery
Do a check of the steering wires
Examine the blades in the cutting deck
Clean the cutting deck, below the belt covers and below the cutting
deck
Make sure that the tire pressure is correct
Do a check of the parking brake
Change the engine oil (the first time after 8 h use)
Change the air filter
Change the fuel filter
Change the spark plug
Do a check of and adjust the throttle wire
Do a check of the belts
Do a check of the fuel hose. Replace it if necessary
To clean the product
CAUTION: Do not use a high pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which cause damage to the
product.
Clean the product directly after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt from on and around
the transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use a high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, remove it and hose it
down with water.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
297 - 002 - 09.11.2017
Daily maintenance
before operation
*
X
*
X
To clean the cold air intake of the
engine
WARNING: Stop the engine. The cold air
intake rotates and can cause injury to your
fingers.
Maintenance interval
in hours
25 50 100 200
X
X
X X
X
X
X
X
O
O
O O
O
15