Radio; Tuning To A Station; Using Presets; Auto Preset Program - RCA RS2622 User Manual

RS2622 EN 12/11/02 5:28 PM

Radio

EN
RS 2622
IR SENSOR
STANDBY
PRESET EQ DIGITAL TUNING
SOURCE TIMER
DIMMER CLOCK PROG•SET
DEMO AUTO PROG
1. Press SOURCE to select TUNER.
2. Press BAND to select between AM or FM radio
band.
Tip: Your audio system has 32 preset stations.

Tuning to a Station

Press SKIP FORWARD
to select frequencies.

Using Presets

The tuner can be in either
TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
Press SKIP BACKWARD
WARD on the main system or PRESET UP or
DOWN on the remote control to access the previous
or next preset station. The display first shows the pre-
set program number and after a few seconds, the fre-
quency and preset program number will be displayed.
(FMPR:01 is FM preset 1)
Auto Preset
Programming
(for FM only)
Press and hold BAND
button for 2 seconds to scan stations in FM band. The
stations will then be stored as preset channels. A maxi-
mum 32 stations can be stored. Beware of your preset
channels being erased accidentally because the scan-
ning and storing process is automatic upon pressing
the button. You can stop the automatic scan by press-
ing any button, but the erased stations cannot be
recovered.
9
Page 12
CD-R / RW COMPATIBLE

Setting Presets

DISC
SKIP
1. Press TUNE/PRESET button to enter TUNER mode.
TUNER PRESET
2. Press SKIP FORWARD
BAND REPEAT
X-SURR. B. BOOST
3. Press the PROG/SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP BACKWARD
move to the desired preset number (1-32).
6. Press PROG/SET to store the selected frequency at
that preset.

Suppressing Stereo Signal

/ BACKWARD
Press FM ST to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
z
87.50 MH
or SKIP FOR-
PR:01
/ BACKWARD
to access the desired frequency.
/ FORWARD to