Speco D8RS User Manual page 20

DATE&TIME Select the display date and time using the mouse or the control button on the remote
SETUP control and press OK button to set the present date and time.
Select DAYLIGHT SAVING using the mouse and the control button on the remote control
and select the appropriate daylight saving time zone. The options are:
OFF: Daylight saving is turned off.
USA: Applies the USA daylight saving time.
EU: Applies the EU daylight saving time.
OTHERS: If the time zone is neither USA nor EU, set the date and time of the daylight
saving period.
Enable/Disable remote access through the network.
CLIENT
ACCESS
NTP NTP (Network Time Protocol) which synchronizes the time of the computer systems over
SETUP variable-latency data networks.
PRIMARY SNTP SERVER: Input the address of the primary NTP time-server.
SECONDARY SNTP SERVER: Input the address of the secondary NTP time-server.
TIME ZONE: NTP synchronizes with GMT (Greenwich Mean Time) regardless of
geography, user must set their own time difference.
CONNECTON MODE: Select the NTP time-server connection mode from TIME,
INTERVAL, and ONCE.
CONNECTION PERIOD
- Select the GMT AREA using the mouse or the control button.
- Set the time difference with the standard time using the mouse or the button.
- Select BEGIN or END using the control button and press the SEL button.
Caution
- Do not set the start time to 23:00 for DLS.
- DLS cannot be applied if the date of BEGIN and END is the same.
TIME – Refresh the time at the designated time (e.g. 1AM)
-
20