Power Failure Indicator; Battery Back-Up Operation - RCA RP3715 User Manual

Rca rp3715 alarm clocks: user guide

Hide thumbs

Table of Contents

Battery Back-Up Operation

This clock radio is equipped with a memory

holding system that can be powered with

a 9-volt battery (not included). The power

failure protection circuit will not operate

unless battery is installed.

When normal household power is inter-

rupted, or AC line cord is unplugged, the

battery will power the clock radio to keep

track of time and alarm settings pro-

grammed into memory. When the battery

backup functions, the digital display will

not light, however, the function of alarm

still occurs during the power interruption

and the radio still operates if remaining

battery power is adequate. Normal op-

eration will resume after AC power is re-

stored so you will not have to reset the

time or the alarm.

tery may be used but memory holding time will be substan-

tially reduced. Memory holding time for a fresh alkaline battery is

approximately 8 hours (if radio or alarm is not operated), which should

take care of short, nuisance-type AC power failures. To preserve

battery life, the radio should remain plugged into an AC outlet. As

batteries get older, their voltage drops and memory may be lost. Be

sure to replace the battery periodically. Battery should be removed

if the radio will be stored for more than one month. Leaky batteries

may badly damage the clock radio.

RP3715 EN-US

Install battery as follows:

1. Remove battery compartment door (lo-

cated on the back of the radio) by ap-

plying thumb pressure to area indicated

on battery door and then lift the door

out and off the cabinet.

2. Connect a 9-volt battery connector plug.

3. Insert battery in the compartment and

replace the compartment door.