Mitsubishi Electric PCA-RP71HA PCA-RP71HA Service Manual page 29

OPERATING PROCEDURE
9. Removing the guide vane
(1) Remove the oil filter. (See figure 1.)
(2) Remove the 3 filter rails. (See photo 1, 4.)
(3) Remove the under panel. (See photo 11.)
(4) Remove the drain pan. (See photo 12.)
(5) Remove the 3 screws (4
remove the guide vane. (See photo 13.)
10. Removing the vane
(1) Slide the vane to the center of the unit, and pull it towards
you to remove. (See photo 14.)
Caution for installation
When installing the vane, check that its
projection is on the left-rear side.
Projection
11. Removing the heat exchanger
(1) Remove the oil filter. (See figure 1.)
(2) Remove the 3 filter rails. (See photo 1, 4.)
(3) Remove the under panel. (See photo 11.)
(4) Remove the drain pan. (See photo 12.)
(5) Remove the 2 screws (4
remove the pipe cover. (See photo 15.)
(6) Remove the 3 screws (4
exchanger. (See photo 15, 16.)
(7) Remove the 2 screws (4
top of the unit, and remove the heat exchanger.
(See photo 17.)
Photo 17
Screws for
Heat exchanger
(top)
10) for guide vane, and
10) for pipe cover, and
10, left: 2, right: 1) for heat
10) for heat exchanger at the
Heat exchanger
29
PHOTOS
Photo 13
Guide vane
Drain pan Screws for guide vane
Photo 14
Vane
Slide
Photo 15
Heat exchanger
Photo 16
Heat exchanger
Screws for
Heat exchanger
(left)
Slide
pipe cover
Screw for
Heat exchanger
(right)
Screw for
pipe cover