10 TUNING THE CHASSIS
10.16
10.17
46
Handlebar position
A01168-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
A01169-10
The holes on the handlebar support
A
of
from the center.
Hole distance A
3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
Info
In addition, the handlebar can be mounted rigidly or on a
rubber bearing.
Preparatory work
–
Take off the handlebar cushion.
Main work
–
1
Remove screws
. Take off handlebar clamp
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
7
Remove the screws
and bushing
3
support
.
Adjusting the handlebar position with the handlebar clamp in
the rubber bearing
–
Position the rubber bushings
–
Place the handlebar support in the required position.
Info
The handlebar support is longer and higher on one
side.
1
are placed at a distance
2
. Take off
6
. Take off handlebar
4
5
and
.