Table of Contents
Advertisement
Reference
Programming the Remote
Control
®
The DSS
remote can be programmed to control most
brands of remote controllable televisions.
Programming the Remote to
Control a TV
To determine whether the remote needs to be
programmed, turn the TV on, point the remote at the TV,
and press the TV button. Then press CHAN UP or DOWN
to see whether the TV responds to the remote commands.
Follow these steps to program your remote to control
your TV.
1. Turn on the TV.
2. Look up your brand and code number(s) on the TV
Code list on page 51.
3. Press and hold the TV button.
4. Enter the three-digit code from the code list.
5. Release the TV button and press OFF•ON or CHAN UP/
DOWN to see if the TV responds to the remote
commands. If it doesn't, try the next code listed for
your brand.
6. Repeat these steps until the TV responds to the
remote commands.
Using the Remote Buttons to
Control a TV
Once the remote has been programmed with the correct
codes, you are ready to use it to control your TV.
To operate the device:
1. Press the TV button to set the remote to control the
TV.
2. Press OFF•ON to turn the TV off or on.
3. Use the remote buttons to control the TV.
50
This remote may not operate all
models of the brands that are shown.
Use the codes shown in this manual,
or on the sheet packed with your
remote.
After you program the remote to
control your TV, record your TV code
here for easy reference.
Advertisement
Table of Contents
